Home » railML newsgroups » railML.infrastructure » [railML 3] railway signal modeling (Need to discuss a way to represent railway signal aspects using railML 3.2)
Re: Definition suggestion for isMovementSignal and its suggested attributes [message #3205 is a reply to message #3201] Tue, 12 March 2024 08:57 Go to previous messageGo to previous message
Jörg von Lingen is currently offline  Jörg von Lingen
Messages: 87
Registered: March 2016
Member
Dear Torben,

I have two clarifications
> "from traffic control" is defined through signalIL@isWired
> (defined as is Central Controlled)
signalIL@isWired is just related electrical wiring.
"from traffic control" means really the command is initiated from a
(central) traffic controller.

> "by optical means" is defined through signalConstruction@type=light
"by optical means" is not necessarily a light signal. It can also be a
marker board (although it does not contain the explicite command
content). It shall be anything the driver can see outside at the track.


Dr.-Ing. Jörg von Lingen - Interlocking scheme coordinator
railML.org (Registry of Associations: VR 5750)

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Export linear location information for switch tip/left/right branch and crossings
Next Topic: [railML3.3] Signal combinations
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sun May 19 14:11:10 CEST 2024