Forum: railML.infrastructure » Attributes for signals and switches

Home » railML newsgroups » railML.infrastructure » Attributes for signals and switches

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Attributes for signals and switches [message #195 is a reply to message #194]

Mon, 01 October 2007 16:06

Joachim.Rubröder
Messages: 33
Registered: September 2004

Member

Hello,
OK your right, the "Durchrutschweg" starts at a signal (possible exit
signals of a station) at all times.

But isn't there still the problem, that the "Durchrutschweg" depends on a
specific Train and its braking abilities? The Signal could also be the end
of different routes ("Gruppenausfahrsignal") and therefore may have
different distNearestOverlaps. I think there is either a good
documentation of this attribute and its usage needed or there are some
more attributes missing.

Best regards,
Joachim Rubröder

Report message to a moderator

[Message index]

		Attributes for signals and switches By: Heidrun Jost on Thu, 27 September 2007 16:07
		Re: Attributes for signals and switches By: Joachim.Rubröder on Fri, 28 September 2007 14:58
		Re: Attributes for signals and switches By: Heidrun Jost on Mon, 01 October 2007 08:59
		Re: Attributes for signals and switches By: Joachim.Rubröder on Mon, 01 October 2007 16:06

Previous Topic:	New working draft of the infrastructure schema available
Next Topic:	Moving of "infrastructureVisualizations"

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue May 14 00:29:20 CEST 2024