Home » railML newsgroups » railML.infrastructure » [railML3] How to assign a mileage change to a netElement (Assignment of a mileage change (kilometer jump) which is valid only for one of several parallel tracks belonging to the same line)
Re: [railML3] How to assign a mileage change to a netElement [message #2841 is a reply to message #2834] Tue, 19 October 2021 17:36 Go to previous messageGo to previous message
Karl-Friedemann Jerosch is currently offline  Karl-Friedemann Jerosch
Messages: 11
Registered: May 2020
Junior Member
Dear Heidrun,

first thank you very much for providing additional 2 solutions for the described problem how to assign mileage changes on netElements.
In the 2nd solution using 1 spot location only, in my opinion there is a risk of misinterpretation, because it is not obviously clear,
if the spot location provides the line kilometer value before or after the kilometer jump.

Conclusion:
Comparing all 3 solutions provided by Christian and the 2 solutions provided by Heidrun, I prefer Heidrun's first solution, where a mileageChange is using 2 spot locations describing the identical location on the track, but each of both with different line kilometer values.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [railML3] Make <track> @type optional
Next Topic: Single and double derailer
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri May 10 11:41:51 CEST 2024