Re: Lateral location of elements [message #1950 is a reply to message #1921] |
Tue, 04 September 2018 11:12 |
Airy Magnien
Messages: 18 Registered: September 2016
|
Junior Member |
|
|
After discussion in the RTM expert group workflow, this is the result:
- Side and positive "offset" (once the side is known) shall be provided
- Semantic clarification: in general, "offset" may be positive or negative, we prefer not to use it in RTM because it may induce misunderstandings; instead:
- Attributes @lateralSide and @lateralDistance are introduced, replacing the proposed @lateralOffset, where @lateralDistance is essentially positive. Rules are: both attributes are optional; if @lateralDistance is provided, it shall be positive or zero, and @lateralSide must also be provided.
- Attributes @verticalSide (proposed values: 'up', 'down') and @verticalDistance also to be adopted, as suggested in the workflow, for reasons of consistency.
[Updated on: Tue, 04 September 2018 11:12] Report message to a moderator
|
|
|