Home » railML newsgroups » railml.interlocking » Definition of Emergency Stop Area for railML 3.3
Definition of Emergency Stop Area for railML 3.3 [message #3140] Sun, 15 October 2023 09:36 Go to next message
heidrun.jost@thalesgroup. is currently offline  heidrun.jost@thalesgroup.
Messages: 5
Registered: December 2022
Junior Member
Dear all,

for railML 3.3 we need the definition of an Emergency Stop Area.

There are two types of Emergency Stop Areas:
1. Conditional Emergency Stop Area // train has to stop if the front end of the train is in rear of the start of the ESA
2. Unconditional Emergency Stop Area //train has to stop in each case

A suggestion would be to use the same definition for Emergency Stop Area like for WorkZone or LocalOperationArea.

However, to use the same approch we must clarify in advance:
What borders are possible for an Emergency Stop Area?
Is at the border in each case a track asset defined (case 1)?
Or is it also possible that the borders are on a pure kilometer value defined without a track asset behind (case 2)?

For case 1 it would be enough to define the Emergency Stop Area only in the interlocking schema, like we did for WorkZone and LocalOperationArea.
For case 2 the definition of the Emergency Stop Area would be necessary in infrastructure (to define the extension) and interlocking schema.

Here an example for an Emergency Stop Area defined only in interlocking schema:

<emergencyStopAreas>
<emergencyStopArea id="IL_Z2MkZDPoiVaqfOJkdtaGyJFa" type="conditional">
<designator register="_costId" entry="EmergencyStopArea:BGS_ESA_BOR"/>
<designator register="_sci_cc" entry="NO_A29_BORESABOR____"/>
<designator register="_longName" entry="BGS_ESA_BOR"/>
<!--commands: NSO, NSOF-->
<hasCommand ref="Z0kA0gRG50Q18PZDDbeIN2Va"/>
<hasCommand ref="IwkLA8DEmOasBk3gMDNTE9"/>
<!--MainSignal:BGS_BOR_L03-->
<isLimitedBy ref="IL_KZZQNdQqiwF0aQBFDe4PNoa"/>
<!--MainSignal:BGS_BOR_M04-->
<isLimitedBy ref="IL_ytQMQbycKIeaAmazUvV8Oa"/>
<!--TrackSection:BGS_BOR_05-->
<trackAssetInArea ref="IL_ZDDQ3u6sLwKfWMciOKX1FFb"/>
<!--Derailer:BGS_BOR_Sp_7-->
<trackAssetInArea ref="IL_Z2QkbTGQeys24OuOVLuzzpb"/>
<!--Point:BGS_BOR_1-->
<trackAssetInArea ref="IL_C547s3mBPL9OU2TFR07IZZ9"/>
<deactivationKey ref="IL_rYAJ3yDJzZD3ZZPqtrAQBKya"/>
<signalWithAspect/>
<!--KeyLockSiding:BGS_BOR_Slas1-->
<keyLockInState id="KL_1">
<givenState>
<relatedLockAndState inState="released">
<refersToKeyLock ref="IL_KN4NRktuSTejZHFEZD66Ae79"/>
</relatedLockAndState>
</givenState>
</keyLockInState>
<levelCrossingInState/>
<releasedForLocalOperation ref="IL_ElkM09NKcKf7UKZZw0dbOTb"/>
</emergencyStopArea>
</emergencyStopAreas>

Therefore the question:
Which borders are possible for Emergency Stop Areas?

Best regards,
--
Heidrun Jost
Data Manager TMS Norway
Transportation Systems
GTS Deutschland GmbH

Phone: +49 (0) 30 688306 423
Schützenstr. 25 10117 Berlin Germany
Re: Definition of Emergency Stop Area for railML 3.3 [message #3167 is a reply to message #3140] Mon, 20 November 2023 06:37 Go to previous messageGo to next message
Jörg von Lingen is currently offline  Jörg von Lingen
Messages: 87
Registered: March 2016
Member
Thanks Heidrun for this post.
The definition of borders of an ESA will come from operational rules of the infrastructure manager.

When considering only IL domain for definition of ESA one would always need some kind of track asset (signal, detection point etc.) as border elements. Otherwise it might be conceivable to define special border elements in IS which are then referred to.

As proposed such ESA can use a similar definition as for WorkZone or LocalOperationArea. However, for the modelling in railML3.3 it needs to be discussed before what is needed in addition to border elements.
1) isLimitedBy = reference to border elements
2) trackAssetInArea = references to any track assets inside (optional/mandatory)?
3) any track asset states?
4) any additional information, e.g. validity?


Dr.-Ing. Jörg von Lingen - Interlocking scheme coordinator
railML.org (Registry of Associations: VR 5750)
Phone Coordinator: +49 351 87759 40; railML.org: +49 351 47582911
Altplauen 19h; 01187 Dresden; Germany www.railml.org
Re: Definition of Emergency Stop Area for railML 3.3 [message #3192 is a reply to message #3167] Wed, 07 February 2024 14:31 Go to previous message
Terje Nordal is currently offline  Terje Nordal
Messages: 9
Registered: December 2023
Junior Member
Dear Heidrun and Jörg,

For a joint Norwegian (Bane NOR and Jernbanedirektoratet) suggestion on how to handle this topic, see the following forum post:
https://www.railml.org/forum/index.php?t=msg&goto=3190.

Best regards
Terje
Previous Topic: Switch/Derailer/Crossing in Overlap requires a position
Next Topic: [railml3] Signal types and functions
Goto Forum:
  


Current Time: Wed Jun 19 15:51:27 CEST 2024