Home » railML newsgroups » railML.infrastructure » Haltetafel / stop post
Re: Haltetafel / stop post [message #491 is a reply to message #479] Mon, 03 December 2012 18:59 Go to previous messageGo to previous message
Christian Rahmig is currently offline  Christian Rahmig
Messages: 151
Registered: January 2011
Senior Member
Dear Susanne,

Am 02.12.2012 22:22, schrieb Susanne Wunsch:
> Christian Rahmig <coord(at)infrastructurerailmlorg> writes:
>
>> just for completeness I want to mention that a stop post can refer to
>> several signals by using the sequence of "signalRef" objects
>> (cp. [2]).
>
> What is the 'sequence' attribute used for?
>
> It's needed that a stop post may refer to several signals, as Carsten
> mentioned at the railML-conference in Zurich. But I don't understand the
> use case where these referred signals have any 'sequence' relation to the
> stop post.

The sequence is not needed. With the latest commit towards Trac ticket
#167 I changed the type of the <signalRef> element to
tElementWithReference leaving out the sequence (cp. [3]).

>> [2] https://trac.assembla.com/railML/ticket/167#comment:16
[3] https://trac.assembla.com/railML/ticket/167#comment:20

Regards

--
Christian Rahmig
railML.infrastructure coordinator
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Shown values on mileposts
Next Topic: Steckenunterbruch/line blocking
Goto Forum:
  


Current Time: Wed May 08 06:05:10 CEST 2024