Re: Haltetafel / stop post [message #499 is a reply to message #491] |
Mon, 03 December 2012 22:44 |
Carsten Weber
Messages: 27 Registered: November 2011
|
Junior Member |
|
|
Here I am.
"Christian Rahmig" <coord(at)infrastructurerailmlorg> schrieb im Newsbeitrag
news:k9j5ch$kb1$1(at)sifaivifhgde...
> Dear Susanne,
>
> Am 02.12.2012 22:22, schrieb Susanne Wunsch:
>> Christian Rahmig <coord(at)infrastructurerailmlorg> writes:
>>
>> It's needed that a stop post may refer to several signals, as Carsten
>> mentioned at the railML-conference in Zurich. But I don't understand the
>> use case where these referred signals have any 'sequence' relation to the
>> stop post.
Such a case exist. (I know only one, but there is one.)
-#----
-#----\
-#---------\-----------
\ |-o
-#------------\-------
|-o
# - stop post
\ - point
|-o - main signal
The real situation includes some more points. But I hope you can see enough
at this sketch.
Do not hesitate to ask if something is not clear.
Best regards.
Carsten
|
|
|