Home » railML newsgroups » railml.rollingstock » propulsion
propulsion [message #1172] Wed, 22 June 2005 11:05 Go to next message
Martin Jacob is currently offline  Martin Jacob
Messages: 4
Registered: January 2006
Junior Member
Hello,

at the moment it is possible to add only one propultion to a engine. I will suggest to use the element propultion as
much as necessry for a engine. It will be usefull for engines which can operate in multiple power supply systems, e.g.
16,7Hz/15kV and 50Hz/25kV.

Martin
Re: propulsion [message #1175 is a reply to message #1172] Tue, 12 July 2005 14:52 Go to previous message
Joerg von Lingen is currently offline  Joerg von Lingen
Messages: 56
Registered: May 2011
Member
Martin,

I have notified this drawback. Subsequently I have changed the occurance of <propulsion> element to unbounded, thus one <propulsion> element can be used for each power supply system.

<xsd:element ref="propulsion" minOccurs="0" maxOccurs="unbounded">
<xsd:annotation>
<xsd:documentation>technical data about the propulsion system of a vehicle</xsd:documentation>
<xsd:documentation>History: V0.91 First release
V0.92 extensive revision, adding all subsystems of propulsion
V0.93 change to user defined type
V1.01 changed to refer to the global element and can occur "unbounded" each for one power supply system</xsd:documentation>
</xsd:annotation>
</xsd:element>

The new schema version will be published in due course.
Regards,
Jörg von Lingen

Martin Jacob wrote the following on 22.06.2005 11:05:

> Hello,
>
> at the moment it is possible to add only one propultion to a engine. I will suggest to use the element propultion as
> much as necessry for a engine. It will be usefull for engines which can operate in multiple power supply systems, e.g.
> 16,7Hz/15kV and 50Hz/25kV.
>
> Martin
Previous Topic: specification of auxiliary power for wagon
Next Topic: valueTableType
Goto Forum:
  


Current Time: Wed Mar 29 11:17:33 CEST 2017